Innovative Eco-friendly Cleaning Technology

Vapor Blast Systems are developers and manufacturers of cleaning equipment, based on innovative, hybrid technology, combining hydro and pneumatic abrasive blasting methods. The approach was initially developed for aero-space industry, however due its low resource consumption and ecology friendliness is recommended for use in all industries including:

• Metal

• Manufacturing

• Machinery

• Building

• Energy

• Sector

• Construction

• Municipal

• Services

Traditional cleaning methods such as sandblasting and acid baths are expensive, with high resource consumption, slow, and can cause numerous ecological and health hazards. These are also very rough cleaning methods that often cannot achieve the quality required in modern manufacturing and construction.

Many modern industries struggle to optimize anti-corrosion protection technology. The results are up to 60% dependent on quality of surface preparation. The surface cleaning method pioneered by Vapor Blast Systems yields the highest results with minimal environmental impact.

Our hybrid, hydro-pneumatic abrasive cleaning method allows manufacturers and maintenance crews to solve wide spectrum of cleaning challenges maximizing surface finish quality, while minimizing erosion of the material and reducing the process cost. The resulting surface finish corresponds to NACE No. 1/SSPC-SP 5 (SA 3) White Metal standard requirements with surface roughness value from 5 Ra to 0.2 Ra.

Using Vapor Blast Systems equipment for surface cleaning yields multiple advantages:

• Higher longevity of anti-corrosion protection with hybrid hydro-pneumatic abrasive surface preparation
• No additional thermal effect on the surface.
• Controlled removal of unwanted material from cleaned surface.
• Increased adherence to surface coating.
• Minimal peening during cleaning process.
• No penetration and sticking of abrasive to primary surface material.
Optional use of passivation chemicals during cleaning process will increase maximum time before surface coating.
• Cleaning process is environment friendly with no active chemical compounds used.

Камеры	Специальные установки	Мобильные установки
КС-100 Камера с ручной обработкой V=1м3 КС-100/А-3D Установка-автомат-3D V=1м3 КС-1401 Камера с ручной обработкой V=4м3	Очистка отрезков труб Очистка труб малого диаметра Очистка внутренней поверхности труб	МБ-140 Установка открытого типа V=0,25м3 МБ-80 Установка напорного типа V=0,08м3